Whirlpool GOA 9523/WH Instrukcja Obsługi Pobierz pdf (Strona 2)

SAVE THESE INSTRUCTIONS

INSTALLATION

After unpacking the hob, make sure that it has not been damaged during transport. In the event of problems, contact the dealer or your nearest After-sales Service.

TECHNICAL INFORMATION FOR THE INSTALLER

• Use protective gloves for handling, preparing and installing the product.

• This product can be embedded in a worktop 20 ÷ 60 mm thick.

• If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in the work surface. This panel must

be positioned at a maximum distance of 150 mm below the upper surface of the work surface but, in no case less than 20 mm from the bottom

of the hob. In the case that you intend to install an oven beneath the hob, make sure that it is equipped with a cooling system. The manufacturer

declines all liability if another brand oven is installed beneath the hob.

Before installation, make sure that:

• thelocalgasdeliveryconditions(natureandpressure)arecompatiblewiththesettingsofthehob(seetheratingplateandinjectortable);

• theoutersurfacesofthefurnitureorappliancesadjacenttothehobareheatresistantaccordingtolocalregulations;

• thisapplianceisnotconnectedtoafumeexhaustdevice.Itshallbeinstalledinaccordancewithcurrentinstallationregulations.Particularattentionshall

begiventotherelevantrequirementsregardingventilation;

• combustionproductsaredischargedoutdoorsthroughspecichoodsorwalland/orwindowmountedelectricalfans.

GAS CONNECTION

WARNING

This operation must be performed by a qualied technician.

• The gas supply system must comply with local regulations.

• Youcanndspeciclocalregulationsforsomecountriesintheparagraph“ReferencetoLocalRegulations”.

If no information concerning your Country is given, please ask details to your Installer.

• The connection of the hob to the gas pipe network or gas cylinder must be made by means of a rigid copper

orsteelpipewithttingscomplyingwithlocalregulations,orbymeansofacontinuous-surfacestainlesssteel

hosecomplyingwithlocalregulations.Themaximumlengthofthehoseis2linearmetres.

• Connect elbow (A)* or (B)* supplied with to the hob inlet main pipe and interpose the washer (C) supplied,

in compliance with EN 549.

* Use elbow (A) for France and elbow (B) for all other destinations.

IMPORTANT: if a stainless steel hose is used, it must be installed so as not to touch any mobile part of

the furniture. It must pass through an area where there are no obstructions and where it is possible to

inspect it on all its length.

• Afterconnectiontothegassupply,checkforleakswithsoapywater.Lightuptheburnersandturntheknobs

frommaxposition to minimum position tocheckamestability.

ELECTRICAL CONNECTION

WARNING

This operation must be performed by a qualied technician.

Earth

(yellow/green)

WARNING

• The electrical connections must comply with local regulations.

• The earthing of this appliance is compulsory by law.

• Do not use an extension cord.

IMPORTANT: the data relevant to the voltage and power absorption are indicated on the rating plate.

ASSEMBLY

After having cleaned the perimeter surface, apply the supplied gasket to the hob as shown in the gure.

PositionthehobintheworktopopeningmaderespectingthedimensionsindicatedintheInstruction.

NOTE: the power supply cable must be long enough to permit its upward extraction.

1 2 3 4 5 6 7

Komentarze do niniejszej Instrukcji

Brak uwag

Whirlpool GOA 9523/WH Instrukcja Obsługi Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Płyty grzewcze Whirlpool GOA 9523/WH