Whirlpool TI 7624 (NR) (T) Instrukcja Obsługi Pobierz pdf (Strona 14)

Other types of connection

! The cable provided is not suitable for the following

types of installation.

If the mains supply corresponds with one of the

following:

Voltage and mains frequency

 400V 2 - N ~ 50 Hz

 230V 3 ~ 50 Hz

 230V 2 + 2 - N ~ 50 Hz

proceed as follows:

1. Use a suitable supply cable, H05RR-F or higher, with

the right dimensions (cable section: 1.5 mm).

2. To open the terminal board, insert a screwdriver into

the side tabs of the cover (see Terminal board picture).

3. Loosen the cable clamp screw and the terminal board

screws according to the type of connection required and

position the connection supports as shown in the

following table and diagrams.

4. Position the wires according to the following table and

diagrams and connect the appliance by tightening all

the screws for the springs as much as possible.

Two-phase

5. Secure the power supply cable by fastening the clamp

screw then put the cover back on.

Connecting the supply cable to the mains

If the appliance is being connected directly to the mains

an omnipolar circuit-breaker must be installed with a

minimum opening of 3 mm between contacts.

! The installer must ensure that the correct electrical

connection has been made and that it is compliant with

safety regulations.

Before connecting to the power supply, make sure that:

 The appliance is earthed and the plug is compliant

with the law.

 The socket can withstand the maximum power of the

appliance, which is indicated on the attached data

plate.

 The power supply voltage is in the range between the

values indicated on the data plate.

 The socket is compatible with the plug of the

appliance. If the socket is incompatible with the plug,

ask an authorised technician to replace it. Do not use

extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be easily

accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced by

authorised technicians only.

! The manufacturer declines any liability should these

safety measures not be observed.

Three-phase 400 2+N

Three-phase 230

Phase Neutral EarthPhase Neutral

U-bolt

connection

support

PhasePhase Neutral Earth

U-bolt

connection

support

Phase PhasePhase Earth

Voltage and

mains

frequency

Electrical connections

Terminal

board

400V 2-N ~

50 Hz

Three-phase

400 2+N

230V 3 ~ 50 Hz

Three-phase

230

230V 2+2-N ~

50 Hz

Two-phase

N2N1

1 2 3 4

L1 L2 L3

1 2 3 4 5

L1 L2 N

1 2 3 4 5

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Komentarze do niniejszej Instrukcji

Brak uwag

Whirlpool TI 7624 (NR) (T) Instrukcja Obsługi Strona 14

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Płyty grzewcze Whirlpool TI 7624 (NR) (T)