Whirlpool K1G11S(W)/I Instrukcja Obsługi Strona 15

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 36
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 14
GB
15
HOOD
420
Min.
min.
650
mm. with hood
min.
700
mm. without hood
mm.
600
Min. mm.
420
Min. mm.
Installation of the cooker
The appliance can be installed next to furniture units
which are no taller than the top of the cooker hob.
The wall in direct contact with the back panel of the
cooker must be made of non-flammable material.
During operation the back panel of the cooker could
reach a temperature of 50°C above room
temperature. For proper installation of the cooker,
the following precautions must be taken:
a)a)
a)a)
a)The appliance can be placed in a kitchen, dining
room or bedsit, but not in a bathroom.
b)b)
b)b)
b )All furniture around the appliance must be placed
at least 200 mm from the top of the cooker,
should the surface of the appliance be higher than
the worktop of this furniture. Curtains should not
be placed behind the cooker or less than 200 mm
away from the sides of the appliance.
c)c)
c)c)
c)Any hoods must be installed according to the
requirements in the installation manual for the
hoods themselves.
d)d)
d)d)
d ) If the cooker is
installed beneath a wall
cabinet, the latter must
be situated at a
minimum of 420 mm
above the hob. The
minimum distance
between the worktop
and kitchen units made
of combustible material
is 700 mm.
e)e)
e)e)
e)The wall in direct contact with the back panel of
the cooker must be made of non-flammable
materials.
Connecting the gas
The appliance should be connected to the mains or
to a gas cylinder in compliance with current
directives. Before making the connection, check that
the cooker is regulated for the gas supply you are
using. If not, follow the instructions indicated in the
paragraph “Adapting to different types of gas”. On
some models the gas supply can be connected on
the left or on the right, as necessary; to change the
connection, reverse the position of the hose holder
with that of the cap and replace replace the gasket
(supplied with the appliance). When using liquid gas
from a cylinder, install a pressure regulator which
complies with current directive.
Important:Important:
Important:Important:
Important: check that the supply pressure
complies with the values indicated in table 1
“Characteristics of the burners and nozzles” since
this will ensure safe operation, correct consumption
and ensure a longer life to your appliance.
Connection with hose
Make the connection using a gas hose complying
with the the characteristics provided in current
directive. The internal diameter of the pipe used is
as follows:
- 8mm for liquid gas;
- 13mm for methane gas.
When installing the hose, remember to take the
following precautions:
No part of the hose should touch parts whose
temperature exceeds 50°C;
The length of the hose should be less than 1500
mm;
The hose should not be subject to twisting or
pulling, and should not have bends or kinks.
The hose should not touch objects with sharp
edges, any moving parts, and it should not be
crushed;
The full length of the hose should be easy to
inspect in order to check its condition;
Check that the hose fits firmly into place at the two
ends and fix it with clamps complying to current
directive.If any of the above recommendations can
not be adopted, flexible metal pipes should be
used.
Should the cooker be installed according to the
conditions of Class 2, subdivision 1, only a flexible
metal pipe which is in compliance with current safety
standards should be used to make the connection to
the gas mains.
Connecting a flexible jointless stainless steel
pipe to a threaded attachment
Remove the hose holder fitted on the appliance. The
gas supply pipe fitting is a threaded 1/2 gas
cylindrical male attachment. Only pipes and gaskets
complying with current directives. The full length of
the pipe must not exceed 2000 mm.
Przeglądanie stron 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Komentarze do niniejszej Instrukcji

Brak uwag