Whirlpool AMD 051 Instrukcja Obsługi Pobierz pdf

BEFORE USING THE APPLIANCE

To make the most out of your new appliance,

please read the user instructions carefully and keep

them handy for future consultation.

Before using the appliance, please follow and

set according to the below indications.

• Remote Control (RC) presetting:

Each time the batteries are replaced in the

remote control, the RC is pre-set on Heat

pump.

If the air conditioner that you purchased is a

cooling only, then the pre-set on Heat pump

will not bring any changes.

• Auto Restart Presetting

If you want auto restart function, hold down the

Emergency button (ON/OFF) on the indoor

unit until the appliance is energized.Auto restart

function is set after the buzz sound three times.

Air conditioner is on standby.

If auto restart has been set, hold down the

Emergency button (ON/OFF) on the indoor

unit until the appliance is energized. Auto

restart function is canceled after the buzz sound

two times. Air conditioner is on standby.

SAFETY PRECAUTIONS

• Do not install the appliance if it is connected to

the power supply.

• The Installation and service/repair must be

performed by a qualified technician, in

compliance with the producer's instructions and

following local safety norms. Do not repair or

replace any parts of the appliance unless it is

specifically written in the user instructions.

• The grounding of this appliance is compulsory.

• Make sure that the power supply cord is long

enough to allow the right connection. Do not

use any extension cord for power supply.

• Do not pull the power supply cord to remove it

from the socket.

• Do not twist or press the power supply cord,

and make sure it is not broken.

• Once installation is completed, the electric

components must not be accessible to the users.

• Do not touch the operation buttons when your

hands are wet and don't use the appliance when

you are barefoot.

• Physically or mentally disabled people, children

and people without any experience with the

product are only allowed to use the appliance if

they have had specific training on how to

operate the appliance by a person responsible

for their security and well-being. The appliance

is not intended for use by disabled people and

very young children without supervision.

1 2 3 4 5 6 ... 20 21

Podsumowanie treści

Strona 1 - SAFETY PRECAUTIONS

25BEFORE USING THE APPLIANCETo make the most out of your new appliance,please read the user instructions carefully and keepthem handy for future consu

Strona 2 - AIR CONDITIONER PRECAUTIONS

34Timer functionIt is convenient to set the timer on by pressing theTIMER ON/OFF buttons to achieve a comfortableroom temperature at the time you get

Strona 3 - PRODUCT DESCRIPTION

35MAINTENANCEUnit1. Unplug from the power supplyTurn off the appliance first before disconnectingfrom power supply.2. To remove the front panel pull i

Strona 4 - DESCRIPTION

36• Install the outdoor unit at a place where the airdischarged and the operation noise would notannoy your neighbours.• Do not place any obstacles in

Strona 5 - AND INDICATORS

37Disposal of the batteriesPlease discard the batteries as sorted municipalwaste at the accessible collection point.To operate the air conditioner, po

Strona 6 - OPERATING MODE DESCRIPTION

38INSTALLATION INSTRUCTIONSInstallation diagramNOTE: The figure above is only a simple presentation of the unit, it may not match the externalappearan

Strona 7

39Select the best locationLocation for Installing Indoor Unit• Where there is no obstacle near the air outletand air can be easily blown to every corn

Strona 8

40INDOOR UNIT INSTALLATION1. Installing the Mounting Plate• Select a location to install the mounting plateaccording to the indoor unit location and p

Strona 9

41IMPORTANT:Piping Joints Thermal Insulation:Wrap the piping joints with thermal insulating materials and then wrap with a vinyl tape.Thermal Insulati

Strona 10

Piping Connection:a. Connect indoor unit pipes with two wrenches. Payspecial attention to the torque allowed as shownbelow to prevent the pipes, conne

Strona 11 - PROTECTION

43WIRING DIAGRAMMake sure that the colour of wires of the outdoor unit and the terminal number are the same as those ofthe indoor unit.Note: For 9k, 1

Strona 12

26• This appliance has been made of recyclable orre-usable material. Scrapping must be carriedout in compliance with local waste disposalregulations.

Strona 13 - Signal receptor

44OUTDOOR UNIT INSTALLATION1. Install Drain Port and Drain Hose (for heat-pump model only)The condensate drains from the outdoor unit whenthe unit ope

Strona 14 - Installation diagram

45How to Purge Air Tubes:(1). Unscrew and remove caps from 2 and 3-way valves.(2). Unscrew and remove cap from service valve.(3). Connect vacuum pump

Strona 15

27PRODUCT DESCRIPTIONIndoor unit1. Air Intake2. Front Panel3. Display panel4. Air Outlet5. Electrical box6. Emergency button7. Vertical Adjustment Lou

Strona 16

28CONTROL PANEL DISPLAY INDICATORSDESCRIPTIONTemperature indicator (1)Displays room temperature.On/Off indicator (2)It lights up during operation.It f

Strona 17

29REMOTE CONTROL FUNCTIONS AND INDICATORS1. ON/OFF BUTTONStarts and/or Stops the appliance by pressingthis button.2. MODE BUTTONUsed to select the ope

Strona 18

30OPERATING MODE DESCRIPTIONOperation Modes:1. Selecting modeEach time MODE button is pressed, the operationmode is changed in sequence:COOLING → DRY

Strona 19 - Te r m i n a l

31AIRFLOW DIRECTION CONTROL5. Airflow direction controlVertical airflow is automatically adjusted to acertain angle in accordance with the operationmo

Strona 20 - OUTDOOR UNIT INSTALLATION

32MODE AND FUNCTION DESCRIPTIONS6th SENSE MODEPress the button, the unit enters 6th sensemode directly regardless of the unit is on or off.In this mo

Strona 21

33Clock functionYou can adjust the real time by pressing CLOCKbutton, then using and buttons to getthe correct time, press CLOCK button again: there