Whirlpool W10222384A Instrukcja Użytkownika Strona 1

24" (61 CM) GAS WASHER/DRYER INSTALLATION INSTRUCTIONS WASHER/DRYER SAFETYTable of Contents WASHER/DRYER SAFETY ...1IN

10Optional exhaust installations This washer/dryer can be converted to exhaust out the right or left side. To convert the washer/dryer, use Side Exhau

11Vent system chartNOTE: Side exhaust installations add a 90º turn inside the dryer. To determine maximum exhaust length, add one 90º turn to the char

Complete Installation1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.2.

2INSTALLATION INSTRUCTIONSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w

3Parts needed:Check local codes and with gas supplier, check existing gas supply, electrical supply and venting, and read “Electrical Requirements,” “

4Washer/Dryer Dimensions*Most installations require a minimum 5" (127 mm) clearance behind the dryer for the exhaust vent with elbow. See “Ventin

5Electrical RequirementsA 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recom

6Must include a shutoff valve:An individual shutoff valve must be installed within six (6) feet (1.8 m) of the washer/dryer in accordance with the Nat

7Remove excess flexible metal vent to avoid sagging and kinking that may result in reduced airflow and poor performance.Do not install flexible metal

8Remove Foam Packing1. Open the washer lid. The latch under the dryer will keep the lid open. 2. Pull the foam packing ring out of the washer.NOTE: Ke

9Connect the inlet hoses to the washer1. Attach the hot water hose to the bottom inlet valve. Attaching the hot water hose first makes it easier to ti