Whirlpool WFC150MLAW0 Instrukcja Naprawy Strona 12

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 18
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 11
FOR SERVICE
TECHNICIAN
ON
L
Y
-
DO
NOT
REMO
VE
OR
DESTRO
Y
POUR
LE
TECHNICIEN
SEULEMENT
-
N
E
P
AS ENLEVER
NI
D
É
TRUIRE
PART
NO.
46197042905
PAGE
12
Date : 14-Feb-2008
F
AIL
URE CODES
DISPLAY
AFFICHAGE
EXPLANATION AND RECOMMENDED PROCEDURE
NO WATER DETECTED ENTERING MACHINE OR PRESSURE SWITCH TRIP NOT DETECTED
Water level is not reached within a defined time in normal wash cycle.
A09
Possible Causes/Procedure
If there is no water in the unit:
Make sure that both valves at the water source(s) are turned on all the way.
Check for plugged or kinked inlet hoses or plugged screens in the inlet valves.
Verify inlet valve operation.
If there is water in the unit:
Verify drain pump operation.
Remove hose from pressure switch. Dislodge any debris build up in the hose inside the outer tub.
Verify that the pressure switch hose is in good condition and properly connected to tub and pressure switch.
1. Verify there is not a siphon problem.
2. Unplug washer or disconnect power.
3. Verify wire harness connections to inlet valves, pressure switch, drain pump and Central Control Unit (CCU).
4. Check all hoses for possible leaks.
5. Plug in washer or reconnect power
6. Verify pressure switch operation.
7. Verify CCU operation by running a Quick Diagnostic Test or any cycle
LONG DRAIN
If the drain time exceeds 4 minutes the water valves turn off.
NOTES:
Rotate knob to clear the display.
A10
Possible Causes/Procedure
1. Check the drain hose and make sure it is not plugged or kinked.
2. Unplug washer or disconnect power.
3. Remove hose from pressure switch. Dislodge any debris build up in the hose inside the outer tub.
4. Check the electrical connections at the pump and make sure the pump is running.
5. Check the drain pump filter for foreign objects.
6. Plug in washer or reconnect power.
7. If the above does not correct the problem, go to step 8.
8. Unplug washer or disconnect power.
9. Replace the pump.
Przeglądanie stron 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Komentarze do niniejszej Instrukcji

Brak uwag