Whirlpool CP 649 MT (X) DK Instrukcja Obsługi Strona 19

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 24
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 18
7
CLEANING AND CARE
FIG. 3
FIG. 2
Before cleaning your oven, or performing maintenance,
disconnect it from the power supply.
To extend the life of your oven, it must be cleaned frequently,
keeping in mind that:
The self-cleaning panels (if present) and the enameled parts
should be washed with warm water - abrasive powders and
corrosive substances should be avoided;
The inside of the oven should be cleaned immediately after
use with warm water and soap; the soap should be rinsed
away and the interior dried thoroughly;
Stainless steel can be stained if it remains in contact with
agressive detergents (containing phosphorus) or water with
a high lime content. We recommend that you rinse these
parts thoroughly and dry them well after cleaning. It is also a
good idea to dry any water spills;
Never line the bottom of the oven with aluminium foil because
the buildup of heat will not only impede the cooking process,
but could also damage the enamel.
Replacing the Lamp in the Oven
Cutoff the supply of power to the oven by turning off the
omni-polar switch connecting it to the mains, or by removing
the plug if it is accessible;
Unscrew the glass cover attached to the lamp holder;
Unscrew the lamp and replace it with another high-tempe-
rature lamp (300°C) with the following characteristics:
- Voltage: 230/240 V
- Wattage: 15W
- Socket: E14
Remount the glass cover and reconnect the appliance to
the power supply.
Disassembling/assembling the oven door
To make it easier to clean the inside of your oven, the oven
door can be removed, by proceeding as follows (fig. 2-3):
Open the door completely and lift the 2 levers “B” (fig. 2);
Now, shutting the door slightly, you can lift it out by pulling out
the hooks “A” as shown in figure 3.
To reassemble the door:
• With the door in a vertical position, insert the two hooks “A”
into the slots;
• Ensure that seat “D” is hooked perfectly onto the edge of the
slot (move the oven door backwards and forward slightly);
• Keep the oven door open fully, unhook the 2 levers “B”
downwards and then shut the door again.
Przeglądanie stron 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Komentarze do niniejszej Instrukcji

Brak uwag