Whirlpool SX 898 C 0 X Instrukcja Obsługi Strona 12

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 11
12
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
2. Use a screwdriver to lift up and turn the small levers F located on the two
hinges(seediagram).
F
3. Grip the door on the two outer sides and
close it approximately half way. Pull the
doortowardsyou,liftingitoutofitsslot(see
diagram). To replace the door, reverse this
sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
pleasecontactyournearestServiceCentre(seeAssistance).Werecommend
that the oven is not used until the seals have been replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: halogen lamp
voltage 230 V, wattage 25 W, cap G 9.
3. Replace the glass cover (see
diagram).
! Do not touch the light bulb directly with your hands.
!Donotusetheovenlampas/forambientlighting.
Sliding rack kit assembly
To assemble the sliding racks:
1. Remove the two frames, lifting them
away from the spacers A(seegure).
2.Choose which shelf to use with the
sliding rack. Paying attention to the
direction in which the sliding rack is to
beextracted,positionjointB and then
jointC on the frame.
3. Secure the two frames with the
guide rails using the holes provided
ontheovenwalls(seediagram).The
holes for the left frame are situated at
the top, while the holes for the right
frame are at the bottom.
4.Finally,ttheframesonthespacers
A.
! Do not place the sliding racks in position 5.
Side and rear catalytic liners
These are panels coated with a special enamel, which is able to absorb the
fat released by food as it cooks.
Thisenamelisquitestrong,sothatthevariousaccessories(racks,dripping
pans,etc.)canslidealongthemwithoutdamagingthem.Whitemarksmay
appear on the surfaces; these are not a cause for concern.
Nevertheless, the following should be avoided:
- scrapingtheenamelwithsharpobjects(aknife,forexample);
- using detergents or abrasive materials.
A
B
C
Left
guide rail
Right guide
rail
Direction
of extraction
D
Przeglądanie stron 11
1 2 ... 7 8 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag