Whirlpool Automatic Ice Maker Przewodnik Instalacji Pobierz pdf (Strona 15)

Refer to the side diagrams for the following

steps.

1. Position the ice maker inside the freezer

compartment and connect its wiring

connector to the wiring harness connector

so they lock together (the locking arm will

snap over the raised tab). The connectors

will fit together only one way.

For Top/Bottom Freezers Only:

Hang the

ice maker over the two hex-head screws

you installed earlier. Make sure that the

bottom mounting bracket hole is aligned

with the mounting hole in the freezer liner,

then tighten the two top hex head screws.

Be careful not to overtighten the screws.

For Side-By-Side Models Only:

Position the

ice maker so that its top and bottom

mounting tabs are flat against the side of

the freezer liner. Center the top tabs under

the two mounting clips, and push the ice

maker straight up so that the mounting clips

snap over the tabs and lock into place (you

should hear them “click” as they lock).

4. Mount the bottom bracket of the ice maker

to the freezer liner mounting hole with a

⁄4

hex-head sheet-metal screw.

Mounting the ice maker

(top and bottom freezers)

Screws

Tabs

Wiring

harness

connectors

1/2" hex-head

sheet-metal

screw

Bottom

mounting

bracket

Mounting the ice maker

(side-by-side models)

Wiring

harness

connectors

Insert fill

tube into

cup

Slide tabs

under clips

Ice maker

⁄2" hex-head

sheet-metal

screw

Bottom

mounting

bracket

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

Whirlpool Automatic Ice Maker Przewodnik Instalacji Strona 15

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Kostkarki do lodu Whirlpool Automatic Ice Maker