Whirlpool Automatic Ice Maker Przewodnik Instalacji Pobierz pdf (Strona 7)

7

INSTALLING THE ICE MAKER

Ice maker wiring cover

Removing the label and foam plug

Foam insert

Label

Remove

this label

for Ice Maker

installation

Spout

Fill tube

Foam

gasket

Installing the fill tube/gasket

Side-by-side models

Refer to the side diagram for the following

steps. You will be working inside the freezer

compartment.

1. Remove the phillips screw from the ice

maker wiring cover and remove the cover.

2. Refer to DETAIL A, and with a pair of pliers,

break away the tabs from the wiring cover

and discard them.

3. Insert the blade of a small screwdriver

under the edge of the round hole plug for

the fill tube, (located at the back of the

freezer liner), and pry it out. You can

discard the plug.

Refer to the side diagram for the following

steps. You will be working on the outside at

the rear of the cabinet.

1. In the upper right corner of the cabinet, peel

off the label that is over the fill tube hole.

2. Pull the foam insert out of the fill tube hole

and discard it.

Refer to the side diagram for the following

steps.

1. Locate the fill tube and the round foam

gasket from the ice maker kit (the gasket

may already be installed on the fill tube). If

not already done, slide the gasket over the

end of the fill tube.

2. Insert the fill tube through the hole in the

rear of the refrigerator with the spout facing

down, and secure it with two

1

⁄2

"

hex-head

sheet-metal screws.

DETAIL A

1

⁄2" hex-head

sheet-metal

screws

Hole cover

Slot

Phillips

screw

Tab

Insert tab

into slot

Pin

Hole

Wiring

harness

Break off and discard

Wiring

cover

Insert pin

into hole

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag