
18
INSTALLATION
Adjustment to different types of gas
If a different type of gas from the one indicated in the plate is
used, the cooking hob must be adapted to it.
1.
The gas nozzles must be changed by After-Sales Service or
a qualified technician.
Nozzles not supplied with the appliance must be ordered
from After-Sales Service.
2.
Connect the cooking hob to the gas shut-off valve by means
of a pipe suitable for the type of gas used, in compliance
with current local regulations.
3.
Adjust the minimum setting of the taps.
Note:
when liquid petroleum gas is used (G 30/G 31), the
minimum gas setting screws must be tightened as far as they
will go.
Replacing the injectors (see table in enclosed product
description sheet)
1.
Remove grids
A
.
2.
Extract burners
B
.
3.
Using a socket spanner of the appropriate size,
C
,
unscrew the injector to be replaced.
4.
Replace it with the injector suitable for the new type of gas.
5.
Re-assemble the injector in
D
.
6.
For models equipped with a triple crown burner, proceed as
shown in figure.
Remove the two screws
F
followed by the cap
G
then
replace both injectors
D
as previously described.
Replace the cap
G
, ensuring the seal is properly
positioned before attempting to use the cooktop.
7.
Before installing the cooktop, remember to affix the gas
calibration plate supplied with the injectors in such a way
that it covers the existing information relating to gas
calibration.
Adjusting minimum gas setting of taps
To ensure that the minimum setting is correctly adjusted,
remove knob
E
and proceed as follows:
tighten (-) to reduce the height of the flame;
loosen (+) to increase the height of the flame.
The adjustment must be performed with the tap in minimum gas
setting position (small flame) .
3gb53211.fm5 Page 18 Monday, June 3, 2002 6:33 PM
Komentarze do niniejszej Instrukcji