6
ELECTRICAL CONNECTION
- Disconnect the appliance from the power supply.
- Installation must be carried out by qualied personnel who know the current safety and installation regulations.
- The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations
provided in this chapter.
- The power cable must be long enough to allow the hob to be removed from the worktop.
- Make sure the voltage specied on the dataplate located on the bottom of the appliance is the same as that of the home.
Connection to the terminal block
For the electrical connection, use an H05RR-F cable as specied in the table below.
Conductors Amount x size
220-240V ~ +
230-240V ~ +
380-425V 2N~ +
220-240V 3~ +
380-415V 3N~ +
3 x 4 mm
3 x 4 mm (Australia only)
4 x 1,5 mm
5 x 1,5 mm
4 x 1,5 mm
The appliance must be connected to the electricity supply by means of an omnipolar switch with minimum contact gap of 3mm.
IMPORTANT: the yellow/green earth wire must be connected to the terminal with the symbol and must be longer than the other wires.
• Check the connection diagram label under the hob and place/remove bridges according the connection type;
• Remove approx. 70 mm of the cable sheath from the power supply cable (B);
• Strip approx. 10 mm of sheath from the wires. Then insert the power supply cable into the cable clamp and connect the wires to the terminal block as
indicated in the connection diagram placed close to the terminal block itself;
• Secure the power supply cable (B) by means of the cable clamp;
• Close the terminal board with the cover (A) securing it with the screw provided;
• After the electrical connection, t the hob inside the cut-out.
CONTROL PANEL DESCRIPTION
Control panel
Timer controls and display
Zone controls and display
On/ Off
Melting
Dual/
Triple
zone
Boiling
Control panel lock
Zone controls and display
Zone controls and display
Zone controls and display
First use / after a power failure
After connecting the hob to the electrical power supply, the control panel is locked (“Lo” showed on the display). To unlock the control panel, touch simultaneously
the controls “Dual/Triple zone” and “boiling”. The display “Lo” switches off and the hob can be used. Read the “Control panel lock” paragraph for more details.
Switching the hob ON/OFF
To switch the hob on, touch the control until the cooking zone displays light up. To switch off, touch the same control until the displays switch off. All the cooking
zones are deactivated. If within 30 seconds of switching on, no function is selected, the hob switches off automatically.
Switching on and adjusting cooking zones
Place the pot on the cooking zone, switching the hob on, activate the required cooking zone by touching the
corresponding “-” or “+” controls: “5” will appear on the display. With “-” and “+” controls it is possible to select the
required power level, from min. 0 to max. 9.
Deactivation of cooking zones
To switch off the cooking zone, touch simultaneously the control “-” and “+” or select the level “0” with the control “-”.
The cooking zone switches off and, if still hot, the letter “H” appears on the zone display.
Power indicator display
Selected cooking zone indication
(the dot blinks when there is a Timer active on that zone)
(4 strony)
(44 strony)
(4 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji