Whirlpool KHRT 7710/I Instrukcja Obsługi Pobierz pdf (Strona 6)

The electrical connection must be made before connecting the

appliance to the power supply. The apparatus must be installed by a

qualified electrician who is fully aware of current safety and installation

regulations. The installation must be carried out in compliance with

regulations of the local electricity company. Make sure that the voltage

shown on the rating plate is the same as the power supply voltage in

your home. Regulations require that the apparatus be earthed: use

conductors of the appropriate size only (including the earth conductor).

The manufacturer declines all responsibility for injury to persons or

animals and for damage to property resulting from failure to observe

the above regulations. For the electrical connection, use a H05 RR-F

cable as indicated in the table below:

Power supply voltage

Conductors Amount per measurement

230V ~ + 3 X2,5 mm

230-240V ~ + 3 X2,5 mm

(Australia only)

230V 3~ + 4 X 1,5 mm

400V 3N ~ + 5 X1,5 mm

400V 2N ~ + 4 X1,5 mm

The appliance must be connected to the electricity supply by

means of a multi-pin disconnecting switch with a minimum

contact gap of 3mm.

Warning: the power supply cable must be long enough to allow the

cooktop to be removed from the worktop and must be positioned so

as to avoid damage or overheating caused by contact with the base.

Connecting to the terminal board

Note: the yellow/green earth wire must be connected to the terminal

with the symbol and must be longer than the other cables.

• Remove approx. 70mm of cable sheath from the power supply cable

(B).

• Strip approx. 10mm of sheath from the wires. Then insert the

power supply cable into the cable clamp and connect the wires to

the terminal board as indicated in the connection diagram near the

terminal board itself.

• Secure the power supply cable (B) using the cable clamp.

• Close the terminal board with the cover (A), using the screws

provided.

• After completing the electrical connection, fit from the top and hook

it to the support springs as illustrated.

Electrical connections

501971902072_GB 12-11-2007 11:14 Pagina 6

1 2 3 4 5 6 7 8 9 10 11 12

Brak uwag

Whirlpool KHRT 7710/I Instrukcja Obsługi Strona 6