Whirlpool SIM561B Instrukcja Obsługi Pobierz pdf (Strona 11)

EN17

The Multizone function is also able to detect when a pot is moved from one zone to the other one within the Multizone area keeping the same power level of the zone

where the pan originally was placed (see the example in the figure below: if the pot is moved from the front heater to the rear heater, the power level will be shown

on the display corresponding to the zone where the pot is placed).

It is also possible to operate the Multizone area as two independent cooking zones, using the corresponding button of the single zone. Place the pot in the center of the

single zone and adjust the power level with the slide touchscreen.

Important: make sure to place the pans centered on the cooking zone in the way to cover the center of the single cooking zone.

In case of big pot, oval, rectangular and elongated pans make sure to place the pans centered on the cooking zone.

Examples of good pot placement and bad pot placement :

IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.

• After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.

• Sugar or foods with a high sugar content damage the hob and must be immediately removed.

• Salt, sugar and sand could scratch the glass surface.

• Use a soft cloth, absorbent kitchen paper or a specific hob cleaner (follow the Manufacturer’s instructions).

• Read and follow the instructions given in the section “Instructions for use”.

• Check that the electricity supply has not been shut off.

• Dry the hob thoroughly after cleaning it.

• If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.

• If the hob cannot be switched off after using it, disconnect it from the power supply.

CLEANING

WARNING

- Do not use steam cleaners.

- Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H”)

is not displayed.

TROUBLESHOOTING GUIDE

ERROR CODE DESCRIPTION POSSIBLE CAUSES ERROR ELIMINATION

C81, C82

The control panel switches off

because of excessively high

temperatures

The internal temperature of electronic

parts is too high

Wait for the hob to cool down

before using it again.

F42 or F43 The connection voltage is wrong

The sensor detects a discrepancy

between the appliance voltage and

that of the mains supply

Disconnect the hob from the

mains and check the electrical

connection

F12, F21, F25, F36, F37, F40, F47, F56, F58,

F60

Call the After-Sales Service and specify the error code

1 2 ... 6 7 8 9 10 11 12 13 14

Komentarze do niniejszej Instrukcji

Brak uwag

Whirlpool SIM561B Instrukcja Obsługi Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Płyty grzewcze Whirlpool SIM561B